.... Errr ..... so i guess i barely mis-measured the size of the insert for the 8-disc poly cases. I ended up being about 10pixels off on the width. Personally i just trimmed a bit off of the edge when i was cutting out the insert. It was almost entirely unnoticeable what i cut off. It would be a PITA to resize everything and remake the template for 10pixels. What do you guys think i should do? I could always just add slight white lines to each side of the covers from here on out?
Wait, the cover is 10 pixels too WIDE, and not 10 pixels too THIN, right?
Honestly, I think that's fine the way it is. Shaving 5 pixels off of each side while cutting out the covers shouldn't be a big deal at all, and barely noticeable. As for the white lines, I think I would advise against it, because not everybody working with your template is going to know to do that. So for consistency's sake, I'd say just keep churning them out the way you have been. Maybe it might be a good idea later on, to update and fix the template, but I really don't think anyone will be bothered by a slight bit of modification needed to be done after printing.
