| General Category > General Discussion |
| Help Me Find A Solution |
| << < (2/2) |
| Polygon:
I had thought about that, and it might be my only option. However, the EA carts were not as wide as the standard Genesis carts so the cart won't fit into the snaps on the sides no matter how I would cut it. So, I would have to do it side ways, but there would be no way to keep it from sliding up and down. I guess I could always glue some plastic in at the edges where the cart would sit. I know it will fit and I have some of those large spline EA cases sitting around that I can try if I can't find another solution. As for the clips. Yeah, they aren't the tightest but when I close the case, even without the manual, it bulges out. |
| AppleQueso:
I don't even have an EA case and mine closes fine. |
| Polygon:
:D It must be me! I'll have to look to see if I have any more of these cases and see if they'll work. Maybe it's just this case. |
| Navigation |
| Message Index |
| Previous page |