| Archive > The Old Request Forum |
| Nintendo DS: Taito Paddle Controller - Double Wide Case |
| << < (2/2) |
| UncleBob:
So, here's some pics of what I did here. I basically stole the idea from the double-wide Wario Ware Twisted case. Sanding down the edges of the two cases on the sides where they join, cutting a hole out of the center and bolting the two together. One minor change is that I had to cut part of the DS game card slot out of the back case - the knob of the paddle controller hit it. Then, I had to cut out a little more because I didn't like the way the case rubbed against the edges of the knob. You can see in the last photo, the knob does - barely - cause the plastic to bulge out a bit... Here's the front part of the case: Here's the front part of the case with the paddle controller in it: And the back-half of the case: And the back cover, taken from an angle to show the bulging knob controller: The pic makes it look worse than it is... |
| UncleBob:
Just found out today (thanks Wikipedia!) that the paddle controller works with Space Bust-a-Move for the DS. Guess I'll need to grab that too.... |
| UncleBob:
Updated links to the scans of the Paddle Controller package... http://www.thecoverproject.net/uploads/raw/Nintendo%20-%20NintendoDS/Tatio.retail.raw_ds_paddle_controller_back_jp.jpg http://www.thecoverproject.net/uploads/raw/Nintendo%20-%20NintendoDS/Tatio.retail.raw_ds_paddle_controller_front_jp.jpg (Finally) Picked up Space Bust-a-Move for $15 at GameStop (new)... Whoo! |
| Navigation |
| Message Index |
| Previous page |