General Category > General Discussion
Matell Intellivision Help!!! Update!! stil need help but got further!!!
Vt102:
Best I remember the INT uses an RF connection (unless there is an AV mod on it).
You will need to use an RCA to Coax cable, plug it into the TV antenna (coax port) and tune the TV to chnl 3 or 4 (analog). The NES RC adapter might work, but it is not a sure shot.
Something like this should do the job.
mizuhime:
Thanks it workish just super blurry so I wonder if it just the flat screen
Tech13:
I doubt it is the tv. You may need to add a Ferrite Choke to the line to the tv to remove some interference in the signal or there my be a voltage regulator or capacitor that needs replacing. I had to do a full recap on my front loader NES not too long ago and I replaced the voltage regulator while I was at it. I use to have the wavy vertical lines everywhere but now it looks great!
mizuhime:
ok thanks I'll check it out and see what I can do