Need help with Cover

[TheFlash24]

Need some help with a sizing issue on a few covers for the UGC's.  I downloaded the Megaman X2 and Megaman 7 cover for custom case for the SNES.  When going into the page setup to print on a legal size paper i choose Landscape and check both boxes for Centering (horizonal and Vertical) and then for Scaling i check the Adjust to 100% normal.  When doing that the page will not print correctly.  The preview shows the upper left corner and thats it. The size of the picutre is 3366x2100. I Printed the Megaman X custom Cover this way just fine.  Any ideas?

[Arseen]

I believe it as easy fix as adjust the margins to minimum.

[TheFlash24]

I think i may have it, i was able to mess with the scaling  and it may fit.  Just weird that some are fine and others arent when they are really the same size.  I've printed a bunch of different ones in b&w and will cut them out later to see what one works

[TheFlash24]

ANd sure enough, none of my test prints worked!  Any idea why they dont size correctly for some and others do?  I tried the margins at 0 and then it automagically adjusts but that also doesnt work

[Arseen]

Go to the properties and see what the size is in centimetres (or inches, but I prefer CM).

Post the measurement here.

Also is the DPI definitely 300?

Or try printing from different program.

[TheFlash24]

I found before i seen your post that the issue was the DPI.  The ones that didnt print right were 120.  I changed them to 300 which were really only like 5 outta 70 and they printed good!