General Category > General Discussion
I'm Customizing Some Games
amiga1200:
:P
a good primer coat as a base (let dry/cure) then a decent spray paint.
an automobile paint can be okay, blast/powder coating is the biz if you get access to a workshop. ;D
if in the habit of 'baning' out cartridge pcb housings, a small set of paints for the job could be thought? (depending how many vs etc...)
Malus_X:
--- Quote from: wiggy on December 27, 2015, 05:27:58 PM ---Yeah, but those snap together SNES cart shells, ick :-\
--- End quote ---
I'm going to keep the original shells from the games, just in case.
Also, how "ick" are we talking here?
TDIRunner:
--- Quote from: Malus_X on December 27, 2015, 08:54:42 PM ---
--- Quote from: wiggy on December 27, 2015, 05:27:58 PM ---Yeah, but those snap together SNES cart shells, ick :-\
--- End quote ---
I'm going to keep the original shells from the games, just in case.
Also, how "ick" are we talking here?
--- End quote ---
Just to make sure, the "snap together" carts are the ones that don't need screws, and in fact have fake screws incorporated into the plastic right?
If so, I've never held them in my hand, but I've seen pictures. They look pretty crappy to me. "Ick" would be putting it nicely.
Arseen:
--- Quote from: TDIRunner on December 27, 2015, 09:56:10 PM ---Just to make sure, the "snap together" carts are the ones that don't need screws, and in fact have fake screws incorporated into the plastic right?
--- End quote ---
Correct
--- Quote from: TDIRunner on December 27, 2015, 09:56:10 PM ---If so, I've never held them in my hand, but I've seen pictures. They look pretty crappy to me. "Ick" would be putting it nicely.
--- End quote ---
Most are bad but I've seen few that are quite close to originals qualitywise.
I still prefer originals.
Malus_X:
So, no ideas outside of painting my carts?
Wonderful.