General Category > General Discussion
Few Questions about NES UGC Modding
Paul:
Okay well I have about 38 Genesis games, 27 N64, and around 80 NES games that I would like to case (thanks to everyone on this site!)
But, I've seen that you have to mod the UGC to fit NES games.
I dug up this thread: http://www.thecoverproject.net/forums/index.php?topic=1044.0
Although I want a little more information if possible.
Is there any easier/quicker way to mod the case to fit NES games in it? Can they sit on top of the inside of the case like you can do with Gameboy games in DS cases?
Thanks everyone!
tiktektak:
Moved to the appropriate section....
shenske:
--- Quote from: Paul on August 15, 2008, 02:37:46 PM ---Okay well I have about 38 Genesis games, 27 N64, and around 80 NES games that I would like to case (thanks to everyone on this site!)
But, I've seen that you have to mod the UGC to fit NES games.
I dug up this thread: http://www.thecoverproject.net/forums/index.php?topic=1044.0
Although I want a little more information if possible.
Is there any easier/quicker way to mod the case to fit NES games in it? Can they sit on top of the inside of the case like you can do with Gameboy games in DS cases?
Thanks everyone!
--- End quote ---
No, the UGCs require you to cut out a couple "chunks" out of it. They are too thick to just set them on top.
Paul:
--- Quote from: shenske on August 15, 2008, 09:03:05 PM ---
--- Quote from: Paul on August 15, 2008, 02:37:46 PM ---Okay well I have about 38 Genesis games, 27 N64, and around 80 NES games that I would like to case (thanks to everyone on this site!)
But, I've seen that you have to mod the UGC to fit NES games.
I dug up this thread: http://www.thecoverproject.net/forums/index.php?topic=1044.0
Although I want a little more information if possible.
Is there any easier/quicker way to mod the case to fit NES games in it? Can they sit on top of the inside of the case like you can do with Gameboy games in DS cases?
Thanks everyone!
--- End quote ---
No, the UGCs require you to cut out a couple "chunks" out of it. They are too thick to just set them on top.
--- End quote ---
approximately how long would it take you per case?
shenske:
~ 10 min w/ soldeing iron
~ 6 min w/ blade (but i get blisters after cranking out a bunch :()