General Category > General Discussion
Universal game case covers don't seem to fit correctly?
TheAristocrat0:
I printed a lot of N64 covers for my universal game cases and I'm confused because all of the covers are bubbling up once I insert them, as though they are slightly too big. I definitely printed them at the correct size and I've measured many times. Does anyone else have this issue?
Jeremy1976:
the three times I have ordered cases they were always a different size
ZX the Hedgehog:
The UGCs seem to be at a different size now, the self-described "slim" UGC - the width inside the case that it takes is exactly 11" to cut down on paper cost for the consumer & manufacturing costs for the company.
To use the covers in these cases, set the dpi to 306 when you print your covers. This will downscale the image to 11" x 6.863", fixing the width issue.
wiggy:
--- Quote from: zxthehedgehog on February 01, 2015, 09:00:41 PM ---The UGCs seem to be at a different size now, the self-described "slim" UGC - the width inside the case that it takes is exactly 11" to cut down on paper cost for the consumer & manufacturing costs for the company.
To use the covers in these cases, set the dpi to 306 when you print your covers. This will downscale the image to 11" x 6.863", fixing the width issue.
--- End quote ---
Where are you finding this info? ???
The only difference is that the sleeves are sometimes welded further in, leaving less room for an insert. Just depends on who's manning the heat seal machine really, which is why it'll vary from batch-to-batch.
monjici:
Have they increased the price again? Last time I ordered it was $59, it's now $69.