HELP PLEASE: Pokemon Box Project

General Category > The Request Forum

<< < (2/3) > >>

CMDLineKing:

--- Quote from: TheBlueEditor on August 08, 2014, 03:01:01 PM ---I'm really liking that so far!!! :) nice work.

--- End quote ---

I have ambitions to do the ENTIRE Series.. Take a gander at these spines... :-P..

TheBlueEditor:
If that's a project you're willing to take on...I would love to see them. :)

CMDLineKing:

--- Quote from: TheBlueEditor on August 08, 2014, 03:59:19 PM ---If that's a project you're willing to take on...I would love to see them. :)

--- End quote ---

It's not that bad.. I had to work on the template a bit.. But The Spines were the most prominent piece.. So I spend more time on that.. I like it.. There is one box that will need to be 4x.. the UNOVA generation..

I did a little research.. I knew there were different regions for each game set.. So I just named the generations by the Region of that Series.. It actually is a lot nicer that "Generation 1" etc.. I listed games in Alphabetical and the non "Launch" titles from each generation LAST. so Yellow, Crystal, Emerald, Platinum, V2. Since they were released after the first games.. I may make a similar set for the other games (JPN Green & Remakes) Maybe call it Pokémon "Remix".

http://pokemon.wikia.com/wiki/Regions

Generation I - Kanto Region
Blue, Red -> Yellow

Generation II - Johto
Gold, Silver -> Crystal

Generation III - Hoenn
Sapphire, Ruby -> Emerald

Generation IV - Sinnoh
Diamond, Pearl -> Platinum

Generation V - Unova
Black and White -> V2 (Sequels Technically)

Generation VI - Kalos
X & Y

CMDLineKing:
Ohh and a quick note.. The top and bottom of the box were different sizes.. I'll figure out the appropriate size, but just noticed it while I was positioning the Box covers on them..

TheBlueEditor:
There probably were a few mistakes on the template. I just kinda through it together based on sizes and stuff but im glad you've taken an interest in it.

Navigation

 Message Index

Go to full version