General Category > General Discussion
PS1 Jewel case Memory card Holder
e_brugal:
how much did you pay for it?
TDIRunner:
That's cool. I would still prefer e_brugal's artwork, but if it was cheap enough, I would get one just for the inside portion.
e_brugal:
Ok, so far this is what i have. only fronts
i know that in the lower one i use the Japanese color (orange) but is so hard to fin good material for the US (red) one. in the lower one you can change the spine name from VMU, MIC or JU PA
Same as the first one, in the lower one Japanese logo.....
The lower one is with the pal logo, name on the spine
and here is the only Red US logo i could find with good quality, in this two names iin the spine is what identify what you have inside
Any comments, changes are acepted, remember that this are only fronts for now ;D
Edit: Ithink i should add the Dreamcast logo in the upper part of the first 3 blacks one
TDIRunner:
These look awesome! ;D
I'll take a closer look this evening when I have more free time. The difficult part will be deciding which one I want to use. ;)
Nice to see the jumper pack in there as well. I still need to engineer a way to fit those in the jewel case. :-\
Crap, I also need more jewel cases. :-[
e_brugal:
--- Quote from: TDIRunner on June 20, 2014, 10:57:35 AM ---These look awesome! ;D
I'll take a closer look this evening when I have more free time. The difficult part will be deciding which one I want to use. ;)
Nice to see the jumper pack in there as well. I still need to engineer a way to fit those in the jewel case. :-\
Crap, I also need more jewel cases. :-[
--- End quote ---
:P lol
I will make some modification and post again later