General Category > General Discussion
May 2014 Pick ups
sebboh:
--- Quote from: sLpFhaWK on May 15, 2014, 08:06:53 AM ---Nice what are you going to print with that bad boy?
--- End quote ---
mostly jewelry molds
Ozzy_98:
print out a case for a gamegear console.
Also, gamegear consoles seem odd. Most people are modding consoles to make them portable...
wiggy:
--- Quote from: sebboh on May 15, 2014, 08:02:59 AM --- after 3 weeks of waiting : )__
--- End quote ---
Curious about your PLA feed setup since it isn't coming off the included mount in the back.
Looks like one of the side panel screws is loose too ;)
--- Quote from: KalessinDB on May 15, 2014, 09:47:38 AM ---
--- Quote from: wiggy on May 15, 2014, 07:50:57 AM ---Re-creating that shell would be VERY easy. There's hardly anything to it. But the work would be time consuming, no doubt.
--- End quote ---
Feels like the shell is the most difficult part to getting a copy of that into my hands. With Tim's RGB out board and maybe a JRok encoder you can have all the video outs you want and the electronics done with little more than soldering point A to point B. Hell, modding the SMS controller to have a start button on it would probably be the most difficult part of the electronics. I for one am only interested in the console/controller, not the packaging he originally did with it.
--- End quote ---
That shell is about as simple a shape as it gets. I could model something like that up in very little time and them just click print ;) It would require a ton of finishing afterwards, but that's just easy busy work.
TDIRunner:
How much Wiggy?
sebboh:
--- Quote from: wiggy on May 15, 2014, 03:24:33 PM ---Curious about your PLA feed setup since it isn't coming off the included mount in the back.
Looks like one of the side panel screws is loose too ;)
--- End quote ---
Don't want to lost time in change the pla filament of the back panel :P. The screw it's due the shitty umi x1 pro camera :P