General Category > General Discussion
UGC cover size?
Blumpkin:
--- Quote from: wiggy on March 19, 2014, 09:12:51 PM ---The sleeve is affixed slightly more inward. Just trim about a half MM extra from each side and you're good to go.
--- End quote ---
This.
I don't print out UGC covers any different now, I just trim a millimeter or so from the left and right borders.
Kriegspire:
Alternatively, you could print at a 99% scale.
helmeto:
--- Quote from: Kriegspire on March 20, 2014, 06:45:39 AM ---Alternatively, you could print at a 99% scale.
--- End quote ---
This is what I do and it works perfectly.
monjici:
--- Quote from: helmeto on March 20, 2014, 07:00:21 AM ---
--- Quote from: Kriegspire on March 20, 2014, 06:45:39 AM ---Alternatively, you could print at a 99% scale.
--- End quote ---
This is what I do and it works perfectly.
--- End quote ---
Does the re-scaling affect the image quality in any way?
It's quite annoying that they changed the case properties, perhaps if everybody complains, they will change it back to the original :)
SNES:
Thanks guys. I just took 5 mm of the lenght, it works fine.
I do have a couple of additional questions.
Do these cases have a tendency to curve inwards on the back? Because all of mine do. By the back I mean the side where all the plastic parts are located for holding the games. I hope you get what I mean. :)
And I have noticed that the covers I print tend to "bobble/crumble" on the middle section of the cases. Perhaps I should use a different kind of paper, rather than standard?