| General Category > General Discussion |
| UGC cover size? |
| << < (2/5) > >> |
| Blumpkin:
--- Quote from: wiggy on March 19, 2014, 09:12:51 PM ---The sleeve is affixed slightly more inward. Just trim about a half MM extra from each side and you're good to go. --- End quote --- This. I don't print out UGC covers any different now, I just trim a millimeter or so from the left and right borders. |
| Kriegspire:
Alternatively, you could print at a 99% scale. |
| helmeto:
--- Quote from: Kriegspire on March 20, 2014, 06:45:39 AM ---Alternatively, you could print at a 99% scale. --- End quote --- This is what I do and it works perfectly. |
| monjici:
--- Quote from: helmeto on March 20, 2014, 07:00:21 AM --- --- Quote from: Kriegspire on March 20, 2014, 06:45:39 AM ---Alternatively, you could print at a 99% scale. --- End quote --- This is what I do and it works perfectly. --- End quote --- Does the re-scaling affect the image quality in any way? It's quite annoying that they changed the case properties, perhaps if everybody complains, they will change it back to the original :) |
| SNES:
Thanks guys. I just took 5 mm of the lenght, it works fine. I do have a couple of additional questions. Do these cases have a tendency to curve inwards on the back? Because all of mine do. By the back I mean the side where all the plastic parts are located for holding the games. I hope you get what I mean. :) And I have noticed that the covers I print tend to "bobble/crumble" on the middle section of the cases. Perhaps I should use a different kind of paper, rather than standard? |
| Navigation |
| Message Index |
| Next page |
| Previous page |