| General Category > General Discussion |
| Sharpening End Nippers? |
| (1/3) > >> |
| Playahstation:
So i'm in the process of modifying the UGC's to NES ready. I tried using the dremel tool, but it was to no avail as the blade kept breaking on me after about a case or so, and would take me another 5 minutes just to get a new one on. So what I have been doing is using the end nipper method to remove the tabs, from their I am sandpapering them down just a little bit and putting foam tape on where the tabs were as well as the top and bottom. it has gone pretty well so far, but I am 12 cases in and I can tell the nippers are not as sharp as they were and there is no way they will survive the 28 NES cases I have left to do. Any suggestions on how I can sharpen the end nippers, or am I shit out of luck and got to go get another pair. |
| quickfingers818:
Honestly, I have been using an oscillating tool I bought real cheap from harbor freight and you can modify a ugc to hold an nes game in a matter of seconds. i would just go that route cause it is much, much faster and pain free. |
| Playahstation:
any idea as too how much one of those would cost at my local home depot or lowes? |
| quickfingers818:
if you get them at a home depot or lowes you will be paying a premium price. but if you get if from a harbor frieght or even on amazon it will only cost you no more than $25.00. |
| Playahstation:
I''ll look into it, thanks for the help :) |
| Navigation |
| Message Index |
| Next page |