General Category > General Discussion
Paper Options
Blumpkin:
I would try it, but my printer isn't big enough to support that stuff.
Arseen:
--- Quote from: Blumpkin on December 23, 2013, 06:58:42 PM ---I would try it, but my printer isn't big enough to support that stuff.
--- End quote ---
Cut it to Legal size?
Ozzy_98:
Cut it in half or thirds across the 19" side, so you have 13" max length, and 8.5 "or 6" wide strips. A bit too wide for my paper cutter though, and I'm not making long cuts like that by hand.
Arseen:
--- Quote from: Ozzy_98 on December 23, 2013, 10:00:32 PM ---Cut it in half or thirds across the 19" side, so you have 13" max length, and 8.5 "or 6" wide strips. A bit too wide for my paper cutter though, and I'm not making long cuts like that by hand.
--- End quote ---
Knife and ruler
Ozzy_98:
Barbaric! At the very least I'd use the table saw, hit the whole stack at once.
... now I wonder what would happen if you ran a stack of paper in a table saw. Hmmm....