Artist's Corner > Universal Game Case Covers
NES Controller Case?
Blumpkin:
--- Quote from: Lashek on December 14, 2013, 03:39:22 PM ---It's all about the cord positioning as the NES connector should be in the middle of the rolled up wire. You have to hollow out the entire inside of the UGC first (including the two long thin tabs at the top and bottom) for it to fit properly, though.
--- End quote ---
Thanks. I was able to make it fit after cutting out the rest of the UGC guts. A little bulgy, but without using wire ties it works for me.
@e_brugal, the change is so small that you won't notice just by looking at them. But the spines are just a hair smaller now from my understanding.
Zeanhaven:
i used old vhs boxed for controller and cables in general, instead of using UGC
shenske:
BitBox cases from StoneAgeGamer work well for storing controllers.
http://www.stoneagegamer.com/nintendo/nes/
Blumpkin:
That looks nice. But the hard (time consuming) part is getting the cord all coiled up perfectly.
shenske:
I just wrapped it around my four fingers and put a rubber band on it. Nothing special, took 15 seconds