DONE - Multiple SNES VERTICAL Covers

General Category > The Request Forum

<< < (3/8) > >>

Arseen:

--- Quote from: videogametrader on October 11, 2013, 11:20:40 AM ---A high res scan of the manual might work

--- End quote ---

For most part yes, but tiny bit of the right most building ( and some bit more to the right) has to be gotten from the label.

videogametrader:
Ok,

So i did some looking up of some Photoshop videos and figured out how to better use the Clone Stamp and that band-aid looking thing. Yes, that is the technical term.

Anyway, here are some before and after shots. I am going to remove completely, the Civilization Logo and the Mouse logo. Then i am going to resize the image and extend the top and bottom. Basically add to the shot with the clone stamp.

Then i will insert the logo and it should be much better then it is now.

Before

After

Arseen:
Looks good, and if extending downwards fails you can alwaysmove the image down and just extend up.

videogametrader:
I am still working on Civilization but i think i can get a Push-Over cover done quicker so I am going to work on this one for the moment.

Let me know what you think so far. The front needed a lot of work (see the raw i had to work with :) but i think it turned out ok.

Here is the RAW. I've learned a lot about photoshop fixing this.

Arseen i am curious if the quality of the front artwork would make your list.

Arseen:
Front looks pretty good, only the butterfly and R need bit more TLC, and whole picture tiny color boost, and it ill make the list.

Navigation

 Message Index

Go to full version