| General Category > General Discussion |
| Noob here in need of info |
| << < (2/5) > >> |
| Richm88:
Ok,also these DVD cases that are used for n64 games, is it as simple as just taking the extra disc slots out or do you add foam with a cutout . Itriedto find a guide on here but could not see one |
| Arseen:
Yep, but I don't bother with the foam, but it's not bad idea and some do use it. Also the cases are 5mm taller than UGCs, so you have 3 options: 1: Use the UGC covers as is (might look bit wierd but not too bad). 2: leave 5 mm white strip to the bottom when you cut (I do this). 3: Stretch the image by 5mm heightwise (I should have done this ;D) |
| larryinc64:
I'm using Blu Ray cases for Dreamcast, I'm working on a template to keep the art from being distorted. |
| scarmullet:
--- Quote from: larryinc64 on May 16, 2013, 05:42:13 PM ---I'm using Blu Ray cases for Dreamcast, I'm working on a template to keep the art from being distorted. --- End quote --- To tell the truth, I don't like the sideways artwork. Can you do it in a fashion where the artwork is properly oriented? |
| larryinc64:
--- Quote from: scarmullet on May 16, 2013, 06:36:49 PM --- --- Quote from: larryinc64 on May 16, 2013, 05:42:13 PM ---I'm using Blu Ray cases for Dreamcast, I'm working on a template to keep the art from being distorted. --- End quote --- To tell the truth, I don't like the sideways artwork. Can you do it in a fashion where the artwork is properly oriented? --- End quote --- The reason the artwork is sideways is so I can keep it retail. I would go with Poly Cases, but Blu Ray cases look better next to DVD cases because they are taller. If it was the other direction, I would have to add big borders. |
| Navigation |
| Message Index |
| Next page |
| Previous page |