| General Category > General Discussion |
| Cleaning? How Do You Do? |
| << < (20/45) > >> |
| Spoonman:
Yes, this is my concern. What is finer than a pocket knife, but just as sharp? Something like a tiny ice pick or something... |
| Dravenae:
Could try a 2mm flat head? |
| Moviefan2k4:
I have a set of very small screwdrivers for eyeglassses, and they sometimes come in handy for stripped game screws. |
| wiggy:
WAY easier solution. Push the two tabs at the top of the cart that are attached to the back side of the shell IN until they snap. This should allow you to essentially unscrew the entire back half of the shell along with the screw that's embedded inside. Make sense? Grab hold of the front of the shell with one hand, the back with the other, and rotate the two as if you were opening a jar. You'll have to pry it apart slightly as you do so to clear the screw bosses and such, but it should work without having to dick around with a zillion tools. |
| Spoonman:
THERE'S an idea. I was fooling with it again last night. Couldn't chip away much of the damage around the center screw and I was pressing on the tabs. Didn't quite figure out that you could do that. Will give it a shot tonight. Thanks Wig! |
| Navigation |
| Message Index |
| Next page |
| Previous page |