General Category > General Discussion
GB/GBC Foam inserts for UGC and SeymoreOnline cases
Seymor Onion:
--- Quote from: videogametrader ---What about just having one single cuttout? I think, because of the shape of the GBA cart, that one cutout will fit the GBA cart securely as well as the GameBoy/GBC carts.
--- End quote ---
One cutout could work; it depends on the integrity of the type of foam ya use.
The motivation behind my design is a worry that the little bump-outs,
on the right and left top of the GBA,
could weaken the short-length foam corners, over time,
hence the need for more foam width along the top of the GBA Cart.
You could also use a more airy/light and less expensive foam.
I'm not sure of the price difference; it's been a while since I priced foam stuff.
--- Quote from: videogametrader ---Have you looked into any places that can make the custom sized foam with the cutouts? I found a place that does it but they seem very expensive. I'm going to keep looking. If i can't get the the foam for under $0.50 each piece then i don't think it will work.
--- End quote ---
Keep looking for places nearby, they should cost less than 50 cents per piece.
Some manufacturers don't have websites, so ya may need to use a phone book.
Another option is www.fabricating.com
They should be able to hook you up with a USA-Based foam manufacturer.
videogametrader:
Ok i got the foam in. It fits perfect in the poly case. I had the prototype made so that i can also fit gamegear games. But this does leave a gap when Game Boy Carts are inserted. I think i can make a third removable foam piece that can fit the GameBoy cart properly. Also, by removing a piece of the foam, GBA carts fit nicely.
One thing i see immediately is that i want to change the orientation of the GBA cart. Anything else?
Any interest in these? I am going to try to retail the foam at $0.50 each. $1.49 with the Poly Case
GameGear Games fit nicely
GameBoy Carts fit with the smal gap - they move around a little in the case but they do stay in the square.
GameBoy Advance carts with by removing one of the foam pieces.
These are the possible ideas for the manuals. I am partial to the last picture.
Please send your suggestions. As i want to have these produced by end of June.
Thanks
Blumpkin:
Can you just rotate the foam 90° so that GBA carts are right side up?
videogametrader:
--- Quote from: Blumpkin on May 16, 2013, 12:06:45 PM ---Can you just rotate the foam 90° so that GBA carts are right side up?
--- End quote ---
Actually, no. The foam is a rectangle and not a square so the foam wont fit the other way. However, since it is being glued down, i can always resize it and make it a little smaller as to be able to be rotated.
Dravenae:
Awesome mate! Keep the games sat the right way up, and go with the fourth idea for the manual sleeve!