| General Category > General Discussion |
| Removing Tabs for NES Cases: Easiest Way? |
| (1/3) > >> |
| wingzrow:
I've tried modifying UGCs for NES cases with an exacto knife AND a dremel. Neither work. An exacto knife is much too slow, and a dremel is too noisy,messy, & it melts the case. How do you guys do it? What would be the easiest way to do a clean job? |
| mojoeskateco:
Dremel works great for me. It does leave a bit of a mess but you can clean it up with an exacto. |
| TyrannicalFascist:
I just go at it with an end cutter. Takes some patience, but gets the job done nicely. |
| segamer:
I use convexed toe nail clipper. I took out the center piece of the clippers. And use pliers to squeeze. |
| Zeanhaven:
i used a razorblade with ducktape at the end to make a handle and slide it, thats what i did |
| Navigation |
| Message Index |
| Next page |