| General Category > General Discussion |
| What do you do for a living? |
| << < (12/17) > >> |
| mojoeskateco:
You don't even need new pin connectors in most cases. Just clean the existing ones and bend the pins back into place. |
| Moviefan2k4:
Bending them back into a proper position would just make it easier to get damaged again. Metal gets weaker the more times its bent. |
| Arseen:
--- Quote from: Moviefan2k4 on September 26, 2012, 04:12:32 PM ---Bending them back into a proper position would just make it easier to get damaged again. Metal gets weaker the more times its bent. --- End quote --- Wait until after it breaks, then replace it. |
| madrocsz:
I have to huge boxes of broken systems if ya want some fun lol. Also 2 more full of working systems that need cables |
| palmer6strings:
--- Quote from: mojoeskateco on September 26, 2012, 03:41:43 PM ---You don't even need new pin connectors in most cases. Just clean the existing ones and bend the pins back into place. --- End quote --- I did on some, and they work great for now, but most of them the plastic around the pins are so brittle they are al broke and the pins are really bent and smashed up. --- Quote from: Arseen on September 26, 2012, 04:16:09 PM --- --- Quote from: Moviefan2k4 on September 26, 2012, 04:12:32 PM ---Bending them back into a proper position would just make it easier to get damaged again. Metal gets weaker the more times its bent. --- End quote --- Wait until after it breaks, then replace it. --- End quote --- Yes, they are at the point of replacing ;) --- Quote from: madrocsz on September 26, 2012, 05:23:47 PM ---I have to huge boxes of broken systems if ya want some fun lol. Also 2 more full of working systems that need cables --- End quote --- What systems if you don't mind me asking? |
| Navigation |
| Message Index |
| Next page |
| Previous page |