| General Category > General Discussion |
| Modding Universal Game Case for NES Carts |
| (1/4) > >> |
| antony30bc:
I am curious what Dremel bit everyone uses for removing the plastic tabs in their Universal Game Case to fit NES carts. I did mine with the cut off wheel however it was not very precise nor clean. Antony30bc |
| tiktektak:
I do it with a soldering iron.... ;D |
| antony30bc:
Do you have a picture of a modified case? If it is cleaner looking when you melt rather than melt/cut as the Dremel does I would switch. Antony30bc |
| tiktektak:
--- Quote from: antony30bc on October 07, 2007, 03:10:44 PM ---Do you have a picture of a modified case? If it is cleaner looking when you melt rather than melt/cut as the Dremel does I would switch. Antony30bc --- End quote --- I'll take a picture when I have time tomorrow. It does look ok but not perfect(I suppose it can't be perfect :) ).... |
| wander2045:
Does anyone have pics of their modded universal game cases? |
| Navigation |
| Message Index |
| Next page |