General Category > General Discussion
Onion game Cases
larryinc64:
I think it was 2 different ideas.
Top line referring to the DS case and the SNES question was unrelated.
Seymor Onion:
--- Quote from: mbs357 on June 25, 2013, 11:26:19 AM ---
--- Quote from: plc268 on June 16, 2013, 11:19:38 AM ---
--- Quote from: Seymor Onion on June 16, 2013, 09:35:43 AM ---Even then, I'm not sure if the GBA Area has grips on it's sidewalls, or not.
I can't tell from the picture.
--- End quote ---
Games fit fine after you cut the top bit, and the sidewalls grip the gba game well.
Here's some pics (the Mother 3 is simply an ezflash 3in1 flashed with Mother 3 with a new label)
http://farm4.staticflickr.com/3779/9057290771_7de673796c_z.jpg
http://farm8.staticflickr.com/7442/9059514282_479fe13445_z.jpg
--- End quote ---
Yea I'm not paying money to carve up perfectly good cases. Plus it looks terrible.
Seymour, is that an accurate portrayal of the final SFC/SNES case?
--- End quote ---
This photo is very close to the actual designs that'll be used for my N64+Memory Card Case, and my NES+SFC Case.
I need to get better 3-D Prints made, and fix any issues that may become apparent with the new prints.
Azarkhel:
Really cool Seymour, i'll stick with UGCs for SNES but every other system i'm coming straight to you.
Spiden:
Those cases are rad!
Seymor Onion:
--- Quote from: Azarkhel on June 28, 2013, 10:47:59 AM ---Really cool Seymour, i'll stick with UGCs for SNES but every other system i'm coming straight to you.
--- End quote ---
Cool beans!
Oh hey, that reminds me...I'm fairly sure if I've mentioned this here already, but...
Any of you who plan to sell off your UGCs (after I finish ironing out the details, and the fundraiser starts)
should probably save a couple of pre-modded UGCs, for your Super Gameboy(s),
and that SFC satellite BSX Cart thing.
I say this because I might not have the Blank Cart Side Mold made, during the first run,
to lower the overall $ that needs to be raised during the fundraiser, by 1 to 2 thousand dollars.
I haven't got final pricing on this yet; only estimates, and it might not cost that much $.
Either way, it's a good idea to keep some UGCs around, that have already been modified,
until I can start making a cases that'll support special carts or accessories,
with little to no modification required by the end-users.