| General Category > General Discussion |
| Onion game Cases |
| << < (90/124) > >> |
| Seymor Onion:
--- Quote from: Tronin on June 16, 2013, 06:42:41 AM ---Will the NES Game Genie fit in your NES cases? --- End quote --- Unfortunately, no, NES Game Genies won't fit in my NES Game Case, as it's about 3/4 of an inch too tall... Well, if you take the black plastic strap off, it'll fit. Say, when you connect two NES Game Genies together, or connect a NES Game Genie to the Top-Loader Adapter, how does their height compare to a NES Game (not counting strap length)? Don't toss that plastic strap, though, because later on, when I start making the one-piece, extra tall DVD Style Cases, for Saturn CD Games and Carts, a NES Game Genie will fit in there, with the strap. --- Quote from: shenske --- --- Quote from: wiggy on June 16, 2013, 08:19:06 AM --- --- Quote from: Rx_79 on June 12, 2013, 10:57:58 AM ---I bought some from somewhere else and the weren't much better. They were black and the plastic was very brittle and cracked when you looked at it. --- End quote --- These are far better quality ;) http://www.genesysdtp.com/index.htm?nintendodscasedetails.htm --- End quote --- Those were the cases Seymor linked at the end of the previous page. Evidently they dont have the gba slot anymore. --- End quote --- There have been reports that the plastic bump in the case has to be cut out, to get GBA Games in em'. Even then, I'm not sure if the GBA Area has grips on it's sidewalls, or not. I can't tell from the picture. |
| JDavis:
--- Quote from: Seymor Onion on June 16, 2013, 09:35:43 AM ---Say, when you connect two NES Game Genies together, or connect a NES Game Genie to the Top-Loader Adapter, how does their height compare to a NES Game (not counting strap length)? --- End quote --- Preeeeetty close. |
| Seymor Onion:
Thanks, JDavis. You are The Man! 8) If one were to remove the straps from both, then you can get two NES Game Genies in my NES Case. The original code book won't fit, but ya'll could always print out some sheets of your favorite codes, and either include them with your Games, or put them in the case with the Game Genies. |
| Seymor Onion:
Assuming ya use the NES Case, and not the Blank-Cart Side case, this is how a single Game Genie would look inside of it: I only have 1 NES Game Genie on hand, at the moment, and I used a 3D-Printed prototype of the NES Game Case. As you can see, the strap sticks out by about 2 inches, so it'd need to be removed if ya'll wanted to put 1 or 2 Game Genies in the NES Case. I don't have a 3D Printed example of the Blank Cart Side, just yet, but as I said in a previous post, on Page 30, the plastic strap is about 1/4 of an inch too long, in that case. |
| plc268:
--- Quote from: Seymor Onion on June 16, 2013, 09:35:43 AM ---Even then, I'm not sure if the GBA Area has grips on it's sidewalls, or not. I can't tell from the picture. --- End quote --- Games fit fine after you cut the top bit, and the sidewalls grip the gba game well. Here's some pics (the Mother 3 is simply an ezflash 3in1 flashed with Mother 3 with a new label) |
| Navigation |
| Message Index |
| Next page |
| Previous page |