General Category > General Discussion
Onion game Cases
Seymor Onion:
Well, there's going to be two main lines of cases.
The Nintendo Main Line (excluding 8-bit Famicom) Cases are going to be larger than UGCs by at least one dimension (spine width).
Case Height and Width will either be the same as UGC, or a little larger.
The Sega Main Line (and a-bit Famicom) Cases will have the same Height and Width as a standard Genesis/Mega Drive Game Case.
However, the spine width will be a little bigger.
I'll be able to post the dimensions, as soon as I get past the Prototyping Phase. ;)
Blumpkin:
Will artwork printed for UGC's fit the new cases?
Arseen:
--- Quote from: Blumpkin on April 24, 2013, 08:04:29 AM ---Will artwork printed for UGC's fit the new cases?
--- End quote ---
--- Quote from: Seymor Onion on April 16, 2013, 09:09:18 AM ---Well, there's going to be two main lines of cases.
The Nintendo Main Line (excluding 8-bit Famicom) Cases are going to be larger than UGCs by at least one dimension (spine width). Case Height and Width will either be the same as UGC, or a little larger.
The Sega Main Line (and a-bit Famicom) Cases will have the same Height and Width as a standard Genesis/Mega Drive Game Case.
However, the spine width will be a little bigger.
I'll be able to post the dimensions, as soon as I get past the Prototyping Phase. ;)
--- End quote ---
But IIRC the difference should not be too big so maybe UGC covers fit as is, or just minimal adjustment.
Seymor Onion:
--- Quote from: Blumpkin on April 24, 2013, 08:04:29 AM ---Will artwork printed for UGC's fit the new cases?
--- End quote ---
Yes, but UGC Artwork will be a little too small.
I am trying to get the Nintendo Main Line Cases, as close to UGC Size, as I can.
The Prototyping Phase is still ongoing.
I hope to be able to post a good update within the next few days.
Been trying to set an appointment to meet with my CAD guy this week.
Arseen:
--- Quote from: Seymor Onion on April 24, 2013, 08:38:56 AM ---
--- Quote from: Blumpkin on April 24, 2013, 08:04:29 AM ---Will artwork printed for UGC's fit the new cases?
--- End quote ---
Yes, but UGC Artwork will be a little too small.
I am trying to get the Nintendo Main Line Cases, as close to UGC Size, as I can.
The Prototyping Phase is still ongoing.
I hope to be able to post a good update within the next few days.
Been trying to set an appointment to meet with my CAD guy this week.
--- End quote ---
If the size is same as Double Wide DVD cases (27.5mm spine) then there is no problem as covers have to be streched 5mm heightwise which is no problem (if not super picky, no streching needed).