General Category > General Discussion
Onion game Cases
<< < (41/124) > >>
Pikmin Overlord:
Perhaps I missed this, but will you be making clear cases, Seymor? It would be great if they somewhat matched UGCs that I already own.
Seymor Onion:

--- Quote from: zakurowrath on August 14, 2012, 08:13:16 PM ---Honestly, I'd just do what easier for you. Black is a pretty much what most people will want but 0.20 or whatever it costs for another colour is fine with me I'd gladly pay the extra cost when they get made.

I can't really think of other colours, I mean, the only games that come to mind are Zelda & Pokemon games, of course people here will probably think of a few more.

Have a question about the Master System & 32x cases. Are they going to be the same size as the original Genesis cases or are they going to be the size of UGC's? Same with the Sonic & Knuckles special case. I believe you said they were going to be the original size, but I could be mistaken.

Can't wait for the announcement on October 13th, only 2 months to go  ;)


--- End quote ---
All 9 Case Types will have the same Outer Dimensions as each other.
They'll be a little bit bigger than the current crop of UGCs.
I have to do this because of limitations inherent in my Modular Mold design.
The only modular parts will be for the inside stuff, like placement of Manual Tabs, Cart Tabs, Cart Walls, and the Tabs and Walls for the n64 Memory Card (the n64 case will accommodate at least one memory card, as well as one n64 Game Cart).

Sonic & Knuckles + the Manual doesn't fit too well in the OEM Genesis Cases.
The OEM Genny case isn't deep enough to do so w/o bulging.

There are similar issues with the other Carts and their Manuals, that a few more mm of Debth, Height and Width can correct.  ;)
Ill be able to give accurate dimensions after the Prototyping Process is complete.


--- Quote from: Pikmin Overlord on August 14, 2012, 08:31:57 PM ---Perhaps I missed this, but will you be making clear cases, Seymor? It would be great if they somewhat matched UGCs that I already own.

--- End quote ---
I added that color option to my notes.
The raw material is clear, so I can simply ask them to not add the Black Dye to X number of them.
Deadpool:
how is this going?
Seymor Onion:
It's going well. After I eat breakfast, I'm going to start painting one of the rooms where the Onion Game Cases are going to be stored.
After that's done, I need to paint one more room.

Why am I painting those two rooms, you might ask?

Last year I had to bring the electrical system in my warehouse up to code.
Most of the attic is inaccessible, because it's really low, so a number of the walls needed sections cut out of them, horizontally, to run the new wiring.
There were a number of holes made in the ceiling as well, that I've patched up, because I had the electricians move a number of Ceiling Light Fixtures to different locations on the ceilings, or just remove, because there were too many of them in some of the rooms.
The original builder went overboard in some of the rooms with the # of light fixtures.

After putting the Sheetrock sections back in the wall, I covered the seams with joint tape and Spackle.
I could just leave it like that, but the Spackle really needs a nice coating of paint on it, to seal it up.

I could just paint over the Spackled parts, but I figure that I might as well do the whole room(s), while I have the opportunity to get it done, since they are currently empty.
Dr.Agon:
you need red cases for VirtualBoy games too!
Navigation
Message Index
Next page
Previous page

Go to full version